[meteorite-list] Cutting meteorites with CBN blade

From: David & Kitt Deyarmin <bobadebt_at_meteoritecentral.com>
Date: Fri, 23 Nov 2007 14:47:37 -0500
Message-ID: <004901c82e09$b33c3570$e3f33842_at_David>

I cut my irons with an MK-100 Brick Paver saw using .030 abrasive blades.

Not only are the blades super cheap, they also produce a very smooth cut
surface.

It takes longer to cut each slice but it saves material and I don't have to
sand out the deep band saw marks




-----------------------------------------------------------------------------------------------------------------------
I found these blades to be real junk and found absolutely no advantage to
using them especially for the higher price. Irons always seem to be best cut
with a band saw by an experienced technician.
Why cut a Nantan? You are asking for trouble....that sucker will likely rust
in front of your eyes!!
Matt Morgan
----------------------
Matt Morgan
Mile High Meteorites
http://www.mhmeteorites.com
P.O. Box 151293
Lakewood, CO 80215 USA

-----Original
Message----------------------------------------------------------------------------------------------------------------------------
From: David Pensenstadler <dfpens01 at yahoo.com>

Date: Fri, 23 Nov 2007 08:37:26
To:Meteorite List <meteorite-list at meteoritecentral.com>
Subject: [meteorite-list] Cutting meteorites with CBN blade


Dear List:

Does anyone have any experience with cutting irons
with a Cubic Boron Nitride blade?

I purchased a 10-inch Pro-Slicer (10 x 0.012) CBN
blade from Lapidary Discounts in California and used
it to cut a 2 1/2 inch Nantan. It worked very well
for the first 10 cuts, then, very quuckly, started to
bind up indicating that the CBN was gone from the
blade. For the cost I expected to get much longer
life from it.

Any opinions on what kind of a life one can expect
from such a blade. Altogether I cut about 22 linear
inches before the blade was useless.

I think I followed good cutting practices, using pella
oil for lubrication, and feeding at a rate of about 1
inch every 5 minutes (0.2 inch per minute).
Motor speed was 1750 rpm.

Any ideas?

Dave
Received on Fri 23 Nov 2007 02:47:37 PM PST